If you don't want to enter these credentials at this time, click Skip instead. If you don't want to change the admin password at this time, click Skip.Įnter the same password that you specified in Step 5.Įnter your username and password (which are used to register software downloads and receive system communications) In the next screen, you are prompted to specify a new admin password (as a security measure). The Cisco DNA Center login screen appears.Įnter the admin's username (admin) and password that you set when you configured your Cisco DNA Center appliance, then click Log In. Mozilla Firefox: Click Accept the Risk and Continue. Google Chrome: Click the Proceed to GUI-IP-address (unsafe) link. Ignore the message and do one of the following: For information on how Cisco DNA Center uses certificates, see the "Certificate and Private Key Support" section in the Cisco DNA Center Administrator Guide. These messages appear because the controller uses a self-signed certificate. The certificate is self-signed, or the server is not sending the correct intermediate certificates. Firefox does not trust GUI-IP-address because its certificate issuer is unknown, Websites prove their identity via certificates. ![]() Mozilla Firefox: Someone could be trying to impersonate the site and you should not continue.This may be caused by a misconfiguration or an attacker intercepting your connection. Google Chrome: This server could not prove that it is GUI-IP-address its security certificate is not trusted by your computer's.Mozilla Firefox: Warning: Potential Security Risk Ahead Google Chrome: Your connection is not private The information described in Required First-Time Setup Information.Īfter the Cisco DNA Center appliance reboot is completed, launch your browser.Įnter the host IP address to access the Cisco DNA Center GUI, using HTTPS:// and the IP address of the Cisco DNA Center GUI that was displayed at the end of the configuration process.Īfter entering the IP address, one of the following messages appears (depending on the browser you are using): The admin superuser username and password that you specified while completing the procedure described in Configure the Primary Node. To log in to Cisco DNA Center and complete the Quick Start workflow, you will need: Complete this workflow to discover theĭevices that Cisco DNA Center will manage and enable the collection of telemetry from those devices. When you log in for the first time as the admin superuser (with the username admin and the SUPER-ADMIN-ROLE assigned), the Quick Start workflow automatically starts. ![]() ![]() Use a compatible, HTTPS-enabled browser when accessing Cisco DNA Center. We recommend that the client systems you use to log in to Cisco DNA Center be equipped with 64-bit operating systems and browsers.Īfter you have installed and configured the Cisco DNA Center appliance, you can log in to its GUI. The Cisco DNA Center GUI is compatible with the following HTTPS-enabled browsers: Complete this step after you have configured the SNMP settings for your appliances. Your cluster nodes to optimize HA operation (see Activate HA). If you plan to deploy high availability (HA) in your production environment, you will need to redistribute services among ![]() Note the following points:įor the parameter information you need to complete this work, see Required First-Time Setup Information. Configure Authentication and Policy ServersĪfter you finish configuring all of the Cisco DNA Center appliances you have installed, perform the tasks described in this chapter to prepare Cisco DNA Center for production use.Integrate Cisco ISE with Cisco DNA Center.
0 Comments
Leave a Reply. |